VOLVO
ECM-P157000 - Intake Manifold Runner Control Circuit High. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (8)
- Volvo S60 (2011–)2014–2015Kun motor: D4204T5
- Volvo S80 (2007–)2014–2015Kun motor: D4204T5
- Volvo V40 (2013–)2015Kun motor: D4204T14
- Volvo V40 Cross Country (2013–)2015Kun motor: D4204T14
- Volvo V60 (2011–)2014–2015Kun motor: D4204T5
- Volvo V70 (2008–)2014–2015Kun motor: D4204T5
- Volvo XC60 (2009–)2014–2015Kun motor: D4204T5
- Volvo XC70 (2008–)2014–2015Kun motor: D4204T5
Hva betyr feilkoden?
The swirl flap motor operates the flaps in the intake manifold, and its signal is monitored by the engine control module (ECM). The code is set when the PWM signal is wrong, and it is checked with the engine running.
Mulige årsaker
- Signal wire shorted to voltage
- Fault in the swirl flap motor
Hva du kan gjøre
- 1Check that the fuses are intact. Their location is in the owner's manual or on the fuse box cover.
- 2With the ignition off, disconnect the connector to the swirl flap motor and use a multimeter to check that the signal wire is not shorted to voltage.
- 3Check the connector to the swirl flap motor for looseness and corrosion.
- 4If you have a diagnostic tool, activate the swirl flap motor and check that it responds to the command.
- 5If the fault remains, have a workshop check the swirl flap motor.
Symptomer du kan merke1
- No noticeable symptoms for the driver
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.