VOLVO
ECM-P162100 - Immobolizer Key Not Programmed - ECM/PCM. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
3 modellerS60 (2011–), S80 (2007–), V70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007–2008Kun motor: B5254T6
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Kun motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
Hva betyr feilkoden?
The engine control module (ECM) lacks the immobilizer code that must match the central electronic module (CEM), so the immobilizer cannot be checked. The engine does not start even though the starter motor turns. The fault code is also set in the event of an internal fault in the engine control module.
Mulige årsaker
- The ECM has not been programmed and holds no immobilizer code
- Damaged engine control module (ECM)
Hva du kan gjøre
- 1Read off the fault codes and note which are present
- 2If the engine control module is not programmed: have a workshop program it
- 3If the engine control module is damaged: have a workshop replace it
- 4After a repair or programming: switch the ignition on, reconnect any disconnected connectors, start the engine and read off the fault codes again
Symptomer du kan merke1
- The starter turns over, yet the engine fails to start
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.