VOLVO
ECM-P162300 - Software Incompatibility with Vehicle Immobilizer Control Module. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
3 modellerS60 (2011–), S80 (2007–), V70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007–2008Kun motor: B5254T6
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Kun motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
Hva betyr feilkoden?
The engine control module (ECM) has either not been programmed or has an internal fault, and then it cannot match the immobilizer code with the central electronic module (CEM). The engine does not start even though the starter motor turns. Although the code describes incompatible software, the condition concerns the immobilizer code itself.
Mulige årsaker
- Damaged engine control module (ECM)
Hva du kan gjøre
- 1Read off the fault codes and note which are present
- 2If the fault code returns: have a workshop replace the engine control module (ECM)
- 3After a repair: switch the ignition on, reconnect any disconnected connectors, start the engine and read off the fault codes again
Symptomer du kan merke1
- The starter turns over, yet the engine fails to start
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.