VOLVO
ECM-P167505 - Injector data not programmed. General Failure Information. System Programming Failures
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (8)
- Volvo S60 (2011–)2014–2015Kun motor: D4204T5
- Volvo S80 (2007–)2014–2015Kun motor: D4204T5
- Volvo V40 (2013–)2015Kun motor: D4204T14
- Volvo V40 Cross Country (2013–)2015Kun motor: D4204T14
- Volvo V60 (2011–)2014–2015Kun motor: D4204T5
- Volvo V70 (2008–)2014–2015Kun motor: D4204T5
- Volvo XC60 (2009–)2014–2015Kun motor: D4204T5
- Volvo XC70 (2008–)2014–2015Kun motor: D4204T5
Hva betyr feilkoden?
The engine control module (ECM) monitors the data that the injectors send over the LIN bus. The fault code is set when the control module receives no communication from an injector. The injector data is then unavailable to the control module, which uses the most recent value instead.
Mulige årsaker
- LIN communication between the injector and the control module is not working
- Internal fault in the injector
Hva du kan gjøre
- 1Read off the fault codes and note which are present before clearing any
- 2Check that the connectors to the injectors are firmly seated and free from corrosion
- 3Clear the fault code, start the engine and let it idle for a while so the control module can run its test
- 4If the fault code returns: have a workshop check the injector and the LIN communication to it
Symptomer du kan merke1
- No noticeable symptoms for the driver
Hva feilen kan påvirke1
- The control module uses the most recently used value from the injector
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.