VOLVO
ECM-P200900 - Intake Manifold Runner Control Circuit Low (Bank 1). General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
8 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (8)
- Volvo S60 (2011–)2014–2015Kun motor: D4204T5
- Volvo S80 (2007–)2014–2015Kun motor: D4204T5
- Volvo V40 (2013–)2015Kun motor: D4204T14
- Volvo V40 Cross Country (2013–)2015Kun motor: D4204T14
- Volvo V60 (2011–)2014–2015Kun motor: D4204T5
- Volvo V70 (2008–)2014–2015Kun motor: D4204T5
- Volvo XC60 (2009–)2014–2015Kun motor: D4204T5
- Volvo XC70 (2008–)2014–2015Kun motor: D4204T5
Hva betyr feilkoden?
The engine control module (ECM) checks how the swirl damper motor works. The code is set when the signal from the learned closed end position of the swirl damper motor is incorrect. The test is only run after a drive, once its conditions are met.
Mulige årsaker
- Defective swirl damper motor
- Swirl damper jams or has stuck
- Damaged swirl damper arm
- Damaged swirl damper end stop
Hva du kan gjøre
- 1Check that the swirl damper is not jammed or stuck in its end position
- 2Check that the swirl damper arm and end stop are not damaged
- 3If you have a diagnostic tool: read the status of the code after a drive to see whether it is active
- 4If the fault remains, have a workshop check the swirl damper motor and carry out a new learning of the end position
Symptomer du kan merke1
- No noticeable symptoms for the driver
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.