VOLVO
ECM-P201700 - Intake Manifold Runner Position Sensor/Switch Circuit High (Bank 1). General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (6)
- Volvo S80 (2007–)2007–2009Kun motor: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Kun motor: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Alle motorer unntatt: B6304T2
- Volvo XC70 (2008–)2008Alle motorer unntatt: B6324S
- Volvo XC70 (2008–)2009Kun motor: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Kun motor: D5244T18, D5244T5
Hva betyr feilkoden?
The supply voltage to the swirl damper position sensor is checked by the engine control module (ECM). The code is set when the signal is wrong, and it is tested with the ignition on. The cause may lie in the supply, in the signal wire or in the sensor itself.
Mulige årsaker
- Trouble code ECM-P201600 can cause this code
- Power supply short-circuited to battery voltage
- Signal wire short-circuited to voltage
- Open circuit in the earth lead
- Damaged sensor
- Short circuit to ground in the signal wire
Hva du kan gjøre
- 1Check that the fuses are intact and that the connectors are secure
- 2Use a multimeter to check that the supply wire is not in contact with battery voltage
- 3Use a multimeter to check that the earth lead to the sensor has no open circuit
- 4If you have a diagnostic tool: read the position sensor signal in live data with the ignition on and check that it changes as the damper moves
- 5If the fault remains, have a workshop with diagnostic equipment check the position sensor
Symptomer du kan merke1
- No noticeable symptoms for the driver
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.