VOLVO
ECM-P212100 - Throttle/Pedal Position Sensor/Switch D Circuit Range/Performance. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerC30 (2007–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V70 (2008–)
Vis modeller per årsmodell og motor (13)
- Volvo C30 (2007–2013)2011–2013Kun motor: D4162T
- Volvo S40 (2004–2013)2011–2012Kun motor: D4162T
- Volvo S60 (2011–)2011–2015Kun motor: D4162T
- Volvo S80 (2007–)2008–2010Kun motor: B4204S3, B4204S4, D4204T
- Volvo S80 (2007–)2011Kun motor: B4204S3, B4204S4
- Volvo S80 (2007–)2012–2015Kun motor: D4162T
- Volvo V40 (2013–)2013–2015Kun motor: D4162T
- Volvo V40 Cross Country (2013–)2013–2015Kun motor: D4162T
- Volvo V50 (2004–2013)2011–2012Kun motor: D4162T
- Volvo V60 (2011–)2011–2015Kun motor: D4162T
- Volvo V70 (2008–)2008–2010Kun motor: B4204S3, B4204S4, D4204T
- Volvo V70 (2008–)2011Kun motor: B4204S3, B4204S4
- Volvo V70 (2008–)2012–2015Kun motor: D4162T
Hva betyr feilkoden?
The control module compares the readings from two accelerator pedal sensors. The code is set when the signal from the accelerator pedal sensor is missing, incorrect or too low. It can also be set wrongly after a module in the car has been reprogrammed.
Mulige årsaker
- Communication fault on the CAN bus
- Damaged accelerator pedal position sensor
- Poor contact, oxidation or a loose plug in the connector
- The signal wire is short-circuited to ground
Hva du kan gjøre
- 1Start by checking the central electronic module (CEM) and the other control modules involved for stored codes, and fix those first
- 2Clear this code only after the codes in the other control modules have been fixed and cleared
- 3If a control module in the vehicle has recently been reprogrammed, the code may have been set incorrectly. In that case you can disregard it
- 4Check that the fuses are intact
- 5Check the connectors at the pedal sensor and the engine control module for contact resistance, looseness and oxidation
- 6If the fault remains, have a workshop with diagnostic equipment trace the CAN communication and the pedal sensor
Symptomer du kan merke3
- Poor response from the accelerator pedal
- A text message and a warning symbol appear in the display
- The engine lacks power and performs poorly
Hva feilen kan påvirke1
- Engine torque may be limited
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.