VOLVO
ECM-P212600 - Throttle/Pedal Position Sensor/Switch E Circuit Range/Performance. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
2 modellerS80 (2007–), V70 (2008–)
Vis modeller per årsmodell og motor (2)
Hva betyr feilkoden?
The engine control module (ECM) has detected that the pulse length of the pulse width modulated (PWM) signal from accelerator pedal sensor circuit 2 is wrong. The fault therefore concerns the accelerator pedal signal. The code can also have been set in error after a control module in the car was reprogrammed, so check whether any module has recently been reprogrammed.
Mulige årsaker
- Damaged accelerator pedal sensor
- Code set in error after a control module in the car was reprogrammed
Hva du kan gjøre
- 1Check whether any control module in the car has recently been reprogrammed, as that can cause this code to be set in error
- 2Check that the accelerator pedal connector and wiring are secure and not chafed or corroded
- 3With a diagnostic tool, check that the pedal value in live data follows slow presses and releases of the pedal
- 4Remedy as needed, then erase the code and road test the car to check that it does not come back
- 5Replace the accelerator pedal sensor only if the fault remains and the wiring is intact
Symptomer du kan merke1
- Poor response from the accelerator pedal
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.