VOLVO
ECM-P230100 - Ignition Coil A Primary Control Circuit High. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
3 modellerS60 (2011–), S80 (2007–), V70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007–2008Kun motor: B5254T6
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Kun motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
Hva betyr feilkoden?
The module monitors the signal wire feeding the primary winding of ignition coil 1. The code is set when the signal to the primary winding is too high.
Mulige årsaker
- Signal wire shorted to supply voltage
- Damaged ignition coil
Hva du kan gjøre
- 1Clear the code, drive the car and read again to see whether it returns
- 2Use a multimeter to check that the signal wire to ignition coil 1 is not shorted to supply voltage
- 3If the wire is in order, ignition coil 1 may be damaged and need replacing
- 4If the fault remains, have a workshop with diagnostic equipment diagnose further
Symptomer du kan merke2
- Malfunction indicator lamp (MIL) lit
- Misfiring, so not every cylinder fires
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.