VOLVO
ECM-P230900 - Ignition Coil D Primary Control Circuit Low. General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
3 modellerS60 (2011–), S80 (2007–), V70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007–2008Kun motor: B5254T6
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Kun motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
Hva betyr feilkoden?
This code applies to ignition coil 4 and says nothing more about the fault type than that the signal to it is too low. The engine control module (ECM) monitors the signal line to the ignition coil primary winding and sets the code when the signal falls below the permitted range.
Mulige årsaker
- The signal wire to ignition coil 4 is short-circuited to ground
- The ignition coil is damaged
Hva du kan gjøre
- 1Check that the relevant fuses are intact; their locations are shown in the car's owner's manual
- 2Read and note the code, clear it, then drive a short distance to see whether it returns
- 3Follow the cable to ignition coil 4 and look for chafing or places where it may have touched the body
- 4Use a multimeter to check that the signal wire to ignition coil 4 has no contact with ground
- 5Check that the connector at ignition coil 4 is firmly seated and free from corrosion
- 6If the fault returns, have a workshop with diagnostic equipment check the ignition coil
Symptomer du kan merke2
- The malfunction indicator lamp (MIL) lights up
- Not all cylinders are firing properly
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.