VOLVO
ECM-P252A17 - Engine Oil Quality Sensor Circuit. General Electrical Failures. Circuit voltage above threshold
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (6)
- Volvo S80 (2007–)2007–2009Kun motor: D5244T4, D5244T5
- Volvo V70 (2008–)2008–2009Kun motor: D5244T4, D5244T5
- Volvo XC60 (2009–)2009Alle motorer unntatt: B6304T2
- Volvo XC70 (2008–)2008Alle motorer unntatt: B6324S
- Volvo XC70 (2008–)2009Kun motor: D5244T4, D5244T5
- Volvo XC90 (2003–)2013–2014Kun motor: D5244T18, D5244T5
Hva betyr feilkoden?
The code concerns an incorrect PWM signal from the combined sensor for oil quality, level and temperature. The cause may be a supply or signal wire with an open circuit or a short to voltage, but a damaged sensor or a poor connection can also be behind it.
Mulige årsaker
- Supply open or shorted to voltage, or the signal wire is open or shorted to voltage
- Contact resistance or oxidation in the connections (see ECM-P252A1C)
- Damaged oil level sensor
- Voltage supply short-circuited to ground (see ECM-P252A16)
- Signal wire short-circuited to ground (see ECM-P252A16)
- Intermittent open circuit in the signal wire (see ECM-P252A1C)
Hva du kan gjøre
- 1Read the fault status with the ignition on and see whether the fault is still active
- 2Check that the relevant fuses are intact
- 3Use a multimeter to check that the supply and signal wires to the combined sensor are not short-circuited to plus
- 4Check the connector to the combined sensor and make sure it is secure and clean
- 5If the fault remains after these checks, have a workshop with diagnostic equipment check the combined sensor
Symptomer du kan merke1
- No noticeable symptoms for the driver
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.