VOLVO
ECM-U201200 - Car Configuration Parameter(s). General Failure Information. No sub type information
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Vis modeller per årsmodell og motor (14)
- Volvo S80 (2007–)2007–2008Kun motor: D5244T4, D5244T5
- Volvo S80 (2007–)2009Kun motor: D5244T10, D5244T4, D5244T5
- Volvo S80 (2007–)2010Kun motor: D4164T, D5244T10, D5244T14, D5244T19
- Volvo S80 (2007–)2011Kun motor: D4164T
- Volvo V70 (2008–)2008Kun motor: D5244T4, D5244T5
- Volvo V70 (2008–)2009Kun motor: D5244T10, D5244T4, D5244T5
- Volvo V70 (2008–)2010Kun motor: D4164T, D5244T10, D5244T14, D5244T19
- Volvo V70 (2008–)2011Kun motor: D4164T
- Volvo XC60 (2009–)2009Alle motorer unntatt: B6304T2
- Volvo XC60 (2009–)2010Kun motor: D5244T10, D5244T14, D5244T16
- Volvo XC70 (2008–)2008Alle motorer unntatt: B6324S
- Volvo XC70 (2008–)2009Kun motor: D5244T4, D5244T5
- Volvo XC70 (2008–)2010Kun motor: D5244T10, D5244T14, D5244T16
- Volvo XC90 (2003–)2013–2014Kun motor: D5244T18, D5244T5
Hva betyr feilkoden?
The engine control module (ECM) checks its own configuration ID against the signal setup that the CEM broadcasts on the CAN network. The modules on the network must share the same signal configuration ID to communicate. The code is set when the module's own ID differs from the one the CEM sends out, and the fault may be because the module is not intended for this car.
Mulige årsaker
- Incorrect configuration ID, because the module is not intended for the car, for example a used module with different software or hardware
- Open circuit in the CAN cables between the module and the central electronic module (CEM)
- Fault in the central electronic module (CEM)
Hva du kan gjøre
- 1Check whether the engine control module is a used module or has been replaced recently. Tell the workshop, since the module must be intended for this car.
- 2Read the fault codes in the central electronic module (CEM) and remedy any faults there first. Do not replace the CEM for a CAN fault unless troubleshooting shows an internal fault.
- 3Look for loose or chafed wires and connectors on the CAN network between the ECM and the CEM. Gently wiggle them to see whether the fault appears.
- 4If a module was replaced without new software being loaded, have a workshop download the correct software, as this requires programming.
Symptomer du kan merke2
- Cruise control cannot be engaged
- Red warning symbol and message in the display
Hva feilen kan påvirke1
- The control module shuts itself off (bus-off)
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.