VOLVO
ECM-U210886 - Cruise Control Front Distance Range Sensor. Bus Signal / Message Failures. Alive / sequence counter incorrect / not updated
System
Motorstyring (ECM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
3 modellerS60 (2011–), S80 (2007–), V70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2011–2012Kun motor: B5254T5
- Volvo S80 (2007–)2007–2008Kun motor: B5254T6
- Volvo S80 (2007–)2009Kun motor: B5254T6, B5254T8
- Volvo S80 (2007–)2010–2011Kun motor: B5254T10, B5254T11, B5254T8
- Volvo S80 (2007–)2012Kun motor: B5254T10
- Volvo V70 (2008–)2008Kun motor: B5254T6
- Volvo V70 (2008–)2009Kun motor: B5254T6, B5254T8
- Volvo V70 (2008–)2010–2011Kun motor: B5254T10, B5254T11
- Volvo V70 (2008–)2012Kun motor: B5254T10
Hva betyr feilkoden?
The engine control module (ECM) continuously receives the information it needs from the forward sensing module (FSM) over CAN and checks the communication. The code is set when communication with the FSM is lost. Although the fault is named a distance sensor problem, it concerns communication with the FSM. After the ECM has been reloaded or the battery has been disconnected, the brake pedal must be pressed for roughly two seconds, with the engine running, before cruise control can be switched on.
Mulige årsaker
- Open circuit in the communication cable
- Communication cable short-circuited to ground
- Communication cable short-circuited to supply voltage
- Contact resistance or oxidation in the connections
- Open circuit in the connections
- Short-circuit in the connections
Hva du kan gjøre
- 1Read the fault codes in the engine control module, the FSM and the CEM. Remedy the FSM faults first, since the engine control module code is then a follow-on fault.
- 2Check that the connectors on the CAN network are secure and clean. Look for chafed wiring and gently wiggle the connectors to see whether the fault appears.
- 3If the fault returns, have a workshop measure on the CAN network with diagnostic equipment, as this requires measurement.
- 4Do not replace the CEM for a CAN fault unless a workshop has confirmed an internal fault in it.
Symptomer du kan merke1
- Cruise control cannot be engaged
Hva feilen kan påvirke1
- Cruise control is turned off while the fault is active
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.