Hva betyr feilkode ICM-U030000?

Diagnose og feilkodedefinisjon for ICM-U030000 (Volvo S60 (2011–), Volvo S80 (2007–), Volvo V40 (2013–)). Bestill reparasjon hos OBD Tuning.

VOLVO

ICM-U030000 - Internal Control Module Software Incompatibility. General Failure Information. No sub type information

System

Infotainment (ICM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

9 modeller

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Vis modeller per årsmodell og motor (9)

Hva betyr feilkoden?

Although the code is named internal software, it applies to the control module's configuration ID on the CAN network. The infotainment control module (ICM) compares its own ID with the signal configuration that the central electronic module (CEM) sends out. If they differ, the code is stored. The control module then switches off its CAN communication.

Mulige årsaker

Incorrect configuration ID, for example a used control module from another car with different software or hardware
Break in the CAN wiring to the central electronic module (CEM)

Hva du kan gjøre

1Has the control module recently been replaced with a used one? Have a workshop check that it is intended for this car and that the right software is loaded
2Check that the connectors in the CAN cables between the infotainment control module and the central electronic module are seated and free from corrosion
3Use a multimeter to check that the CAN cables have no open circuit, and twist and move the cables while measuring
4Do not replace the central electronic module for a CAN fault unless troubleshooting has shown that it is faulty
5Clear the code and switch the ignition on for a while to check that it is not stored again

Symptomer du kan merke2

Infotainment functions do not work
On S80 (07-), V70 (08-) and XC70 (08-) built before late August 2008: the audio unit, the audio unit display or the radio does not work

Hva feilen kan påvirke2

The control module switches off its CAN communication (bus-off)
The control module still responds to the diagnostic tool while the code is stored

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.