VOLVO
IEM-U002888 - Vehicle Communication Bus A. Bus Signal / Message Failures. Bus off
System
Ukjent system / Merkespesifikk
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
1 modellV60 (2011–)
Vis modeller per årsmodell og motor (2)
Hva betyr feilkoden?
The electric rear axle drive module (IEM) sends or receives faulty messages on the sensor CAN, or has lost contact with the sensor CAN. The module then shuts down its communication on the bus. The fault is only checked once the test has started at ignition on, and the code is stored when the conditions are met.
Mulige årsaker
- Break in one or both CAN wires somewhere in the network
- Software error in the electric rear axle drive module (IEM)
- Internal fault inside the ISC voltage converter
Hva du kan gjøre
- 1Read out and note the code, clear it, then start the car and see whether it returns
- 2Have a workshop check that the connectors to the control modules linked to the sensor CAN are fully engaged and free from corrosion
- 3Have a workshop check chafed or damaged CAN cables
- 4Have a workshop with diagnostic equipment check the CAN network and identify which control module is communicating incorrectly, since the fault can lie in the cables or in a control module
- 5Do not work on the electric rear axle or its high voltage system yourself; have a workshop carry out those checks
Symptomer du kan merke4
- Warning symbol and text message in the display
- PURE drive mode disengages by itself or is not available
- AWD drive mode disengages by itself or is not available
- HYBRID drive mode runs with the combustion engine active all the time or too often
Hva feilen kan påvirke3
- The control module switches itself off on the sensor CAN (bus-off) and stays off until the power supply has been disconnected
- Electric propulsion is not possible
- Brake energy recovery from the electric rear axle ERAD is not possible
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.