VOLVO
PBM-U210054 - Control Module Not Configured. System Programming Failures. Missing calibration
System
Drivlinje (Motor og girkasse)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Hva betyr feilkoden?
The electronic parking brake module (PBM) has a built-in inclination sensor used to decide how hard to apply the brake on a slope. The code means the inclination sensor has not been calibrated, the installation check has not been done, or the module is still in service mode.
Mulige årsaker
- The inclination sensor has not been calibrated, for example after replacing the module
- The installation check has not been carried out after fitting
- Service mode is still active, for example after replacing the rear brake pads
Hva du kan gjøre
- 1Find out whether the rear brakes or the parking brake module have recently been serviced or replaced
- 2Have a workshop with diagnostic equipment exit service mode, calibrate the inclination sensor and run the installation check
- 3Afterwards, check that the parking brake applies and releases correctly
- 4Do not rely on the parking brake on a slope until the fault is fixed – leave the car in gear or in P
Symptomer du kan merke3
- Parking brake warning lamp on
- Yellow warning symbol and message in the display
- The parking brake has reduced function
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.