VOLVO
PDM-U001000 - Medium Speed CAN Communication Bus. General Failure Information. No sub type information
System
Passasjerdør (PDM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerS80 (2007–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (4)
Hva betyr feilkoden?
The control modules send and receive information over CAN, a standardised serial communication method. The module has registered that communication on the MS-CAN network is disturbed, either by another control module on the network or by the module's own messages causing interference. The code is set when the module's CAN communication starts.
Mulige årsaker
- Short circuit between the CAN wires
- Open circuit in one of the CAN wires
- Internal fault in another control module on the same part of the CAN network
- Internal fault in the control module
Hva du kan gjøre
- 1Start the car and let it run for a while, then clear the code and check whether it comes back
- 2If you have diagnostic equipment, read the other codes in the car first, as they often show which part of the CAN network is affected
- 3Check the fuses in the fuse box and make sure they are intact
- 4Disconnect the battery negative terminal and use a multimeter to check that the CAN wires have no contact with ground or voltage and no open circuit
- 5Have a workshop look for the control module that disturbs communication and replace it if it is faulty; do not replace the central electronic module (CEM) before it has been checked
Symptomer du kan merke3
- The door mirror memory function does not work
- The electric window does not work
- Outer mirror adjustment does not work
Hva feilen kan påvirke2
- The control module shuts itself off (“bus-off”)
- The control module stays off until the power supply is cut, and it tries to communicate again when the power is reconnected
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.