VOLVO
PSCM-C102300 - Pull Drift Compensation Limit Exceeded. General Failure Information. No sub type information
System
Servostyringsmodul (PSCM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
2 modellerV40 (2013–), V40 Cross Country (2013–)
Vis modeller per årsmodell og motor (2)
Hva betyr feilkoden?
The compensation for oversteer or understeer has gone outside its tolerance. The control module uses built-in sensing to detect whether a wheel is spinning or the car is turning sharply, and then picks a response such as braking one wheel. The cause may lie in the tyres or the suspension.
Mulige årsaker
- Puncture in one or more tyres
- Unevenly worn tyres, compared front and rear
- Tyre with incorrect dimension fitted to the front or rear axle, compared with the other tyres on the car
- Incorrectly adjusted suspension
Hva du kan gjøre
- 1Check that no tyre is punctured and that the pressure is the same in all tyres
- 2Compare the tyre size and wear front and rear with each other and with the other tyres on the car
- 3Check that the tyres on the same axle are of the same size
- 4Clear the fault code and test drive to see whether it returns
- 5If the fault returns after the tyre check: have a workshop check the suspension alignment
- 6Safety note: steering and tyres are safety-critical, so have a workshop carry out the check if the car still pulls
Symptomer du kan merke2
- Steering requires extra or uneven effort
- Steering has excessive free play or wanders
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.