VOLVO
SAS-0001 - LED group 1 circuit. Signal too low
System
Rattvinkelsensor (SAS)
Volvo-modeller feilkoden gjelder for
Feilkoden har ulik betydning avhengig av modell, årsmodell eller motor. Velg betydningen som gjelder din bil.
Gjelder følgende modeller:
5 modellerS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Hva betyr feilkoden?
The steering wheel angle sensor measures the wheel angle with LEDs and receivers that read code wheels, and the control unit monitors the current in LED group 1. The code is set when the current is too low, and then anti-spin and the stability function are blocked.
Mulige årsaker
- Poor contact or oxidation at the connections and connector blocks
- Short-circuit to ground in the LED circuit
- LED 1-4 defective; this applies to this code
- LED 5-8 defective; SAS-0025 is set instead
- Defective control unit
Hva du kan gjøre
- 1With the ignition off, check that the connectors at the angle sensor and the SWM are fully seated and free from oxidation
- 2With diagnostic equipment and the ignition on, read the current in the LED circuit
- 3With a multimeter, check that the cable from the steering wheel angle sensor has no contact with ground (the bodywork)
- 4If the connectors and cables are good, the steering wheel angle sensor may be defective; replacing it is a job for a workshop
- 5Safety: anti-spin and stability are switched off while the fault is present, so have a workshop remedy it; do not work on the steering wheel, steering wheel module or angle sensor yourself
Symptomer du kan merke3
- The anti-spin warning lamp is on
- The stability function does not work
- Anti-spin does not work
Hva feilen kan påvirke2
- The AYC function is blocked
- The anti-spin function is blocked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.