VOLVO
SAS-0002 - LED group 1 circuit. Signal too high
System
Rattvinkelsensor (SAS)
Volvo-modeller feilkoden gjelder for
Feilkoden har ulik betydning avhengig av modell, årsmodell eller motor. Velg betydningen som gjelder din bil.
Gjelder følgende modeller:
5 modellerS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Hva betyr feilkoden?
The steering wheel angle sensor measures the wheel angle with LEDs and receivers, and the control unit monitors the current in LED group 1. The code is set when the current is too high, which switches off the stability function and blocks anti-spin.
Mulige årsaker
- Poor contact or oxidation at the connections and connector blocks
- Short-circuit to supply voltage in the LED circuit
- LED 1-4 defective; this applies to this code
- LED 5-8 defective; SAS-0026 is set instead
- Defective control unit
Hva du kan gjøre
- 1With the ignition off, check that the connectors at the angle sensor and the SWM are fully seated and free from oxidation
- 2With diagnostic equipment and the ignition on, read the current in the LED circuit
- 3With the ignition off, use a multimeter to check that the cables between the angle sensor and the SWM have no contact with voltage (plus)
- 4If the cables are intact, the steering wheel angle sensor may be defective; replacing it is a job for a workshop
- 5Safety: anti-spin and stability are switched off while the fault is present, so have a workshop remedy it; do not work on the steering wheel, steering wheel module or angle sensor yourself
Symptomer du kan merke3
- The anti-spin warning lamp is on
- The stability function does not work
- Anti-spin does not work
Hva feilen kan påvirke2
- The stability function is disconnected
- The anti-spin function is blocked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.