VOLVO
SAS-000C - Control module. Internal fault
System
Rattvinkelsensor (SAS)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
5 modellerS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Vis modeller per årsmodell og motor (11)
- Volvo S60 (2001–2009)2005–2009
- Volvo S80 (1999–2006)2005–2006
- Volvo V70 (2000–2008)2005–2008
- Volvo V70 XC / XC70 (2001–2007)2005–2007
- Volvo XC90 (2003–)2005–2006Alle motorer unntatt: B8444S
- Volvo XC90 (2003–)2007Kun motor: B5254T2, D5244T4
- Volvo XC90 (2003–)2008–2010Alle motorer unntatt: B6324S, B8444S
- Volvo XC90 (2003–)2011Alle motorer unntatt: B6324S5, B8444S
- Volvo XC90 (2003–)2012Alle motorer unntatt: B6324S5
- Volvo XC90 (2003–)2013–2014Kun motor: B5254T9
- Volvo XC90 (2003–)2015
Hva betyr feilkoden?
The steering wheel angle sensor control module has registered an internal fault. The stability control function is blocked while the fault is present. The module is mounted in the lever module, shared with the steering wheel module, and is powered from there.
Mulige årsaker
- Fault inside the SAS control module itself
Hva du kan gjøre
- 1Read and note the code, clear it and road test to see whether it returns
- 2Turn the steering wheel fully to the right, then fully to the left, set it straight ahead and read the code again
- 3With diagnostic equipment, compare the counters for the fault status: many incorrect driving cycles point to a recurring fault
- 4If the code returns, have a workshop replace the steering wheel module (SWM)
- 5The stability function stays blocked while the fault is present, so have a workshop repair it promptly
Symptomer du kan merke3
- Anti-spin warning lamp is on
- General warning lamp is on
- Stability control function not working
Hva feilen kan påvirke1
- Stability function blocked
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.