VOLVO
SAS-B124E1C - Wiper Stalk Switch Pack. General Electrical Failures. Circuit voltage out of range
System
Rattvinkelsensor (SAS)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Vis modeller per årsmodell og motor (8)
- Volvo C30 (2007–2013)2011Kun motor: D4162T, D4164T, D5204T, D5204T5
- Volvo C30 (2007–2013)2012–2013Kun motor: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Kun motor: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Alle motorer unntatt: B5254T7
- Volvo S40 (2004–2013)2011Kun motor: D4162T, D4164T, D5204T, D5204T5
- Volvo S40 (2004–2013)2012Kun motor: D4162T, D5204T, D5204T5
- Volvo V50 (2004–2013)2011Kun motor: D4162T, D4164T, D5204T, D5204T5
- Volvo V50 (2004–2013)2012Kun motor: D4162T, D5204T, D5204T5
Hva betyr feilkoden?
A fault is found when the intermittent setting of the windscreen wiper stalk is tested, and the code is set. The cause is a damaged intermittent wiper switch or an internal fault in the control module.
Mulige årsaker
- Damaged switch for intermittent windscreen wiping
- Internal fault in the sensor control module
Hva du kan gjøre
- 1Check that the fuses are intact
- 2Try each windscreen wiper setting, especially intermittent, to see which one does not work
- 3Read and note the code, clear it and road test to see whether it returns
- 4With diagnostic equipment, follow the status of the intermittent wiper switch in live data while using it
- 5The steering wheel angle sensor is part of the car's safety systems, so have a workshop repair the fault promptly if it remains
Symptomer du kan merke1
- Windscreen wiper does not work
Hva feilen kan påvirke1
- If the wiper is in an active mode, it runs at the lowest speed
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.