VOLVO
SAS-B124E29 - Wiper Stalk Switch Pack. General Signal Failures. Signal signal invalid
System
Rattvinkelsensor (SAS)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Vis modeller per årsmodell og motor (8)
- Volvo C30 (2007–2013)2011Kun motor: D4162T, D4164T, D5204T, D5204T5
- Volvo C30 (2007–2013)2012–2013Kun motor: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Kun motor: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Alle motorer unntatt: B5254T7
- Volvo S40 (2004–2013)2011Kun motor: D4162T, D4164T, D5204T, D5204T5
- Volvo S40 (2004–2013)2012Kun motor: D4162T, D5204T, D5204T5
- Volvo V50 (2004–2013)2011Kun motor: D4162T, D4164T, D5204T, D5204T5
- Volvo V50 (2004–2013)2012Kun motor: D4162T, D5204T, D5204T5
Hva betyr feilkoden?
Two or more of the wiper stalk switches are active at the same time for too long, which sets the code. The wipers may then run only at low speed, and the rear window washer may not work.
Mulige årsaker
- Single sweep and low-speed wiping activated at the same time
- Front and rear washer activated at the same time
- Single sweep and high-speed or intermittent wiping activated at the same time
- Continuous and intermittent rear window wiping activated at the same time
Hva du kan gjøre
- 1Check that the fuses are intact
- 2Try each wiper stalk position and the washer one at a time to see whether any stays active
- 3Read and note the code, clear it and road test to see whether it returns
- 4With diagnostic equipment, follow the wiper stalk switches in live data while the stalk is used
- 5The steering wheel angle sensor is part of the car's safety systems, so have a workshop repair the fault promptly if it remains
Symptomer du kan merke2
- The wipers only operate at low speed
- Rear window washer does not work
Hva feilen kan påvirke1
- If the wipers are in the active position, they run at the lowest speed
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.