VOLVO
SAS-E003 - Configuration fault Faulty configuration
System
Rattvinkelsensor (SAS)
Volvo-modeller feilkoden gjelder for
Feilkoden har ulik betydning avhengig av modell, årsmodell eller motor. Velg betydningen som gjelder din bil.
Gjelder følgende modeller:
5 modellerS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Hva betyr feilkoden?
The steering angle sensor checks its configuration ID against the signal setup that the central electronic module (CEM) transmits over CAN. The code is set when the two disagree, or when the link to the CEM is cut. Ordinary CAN traffic then stops, although the sensor still answers diagnostic requests.
Mulige årsaker
- Wrong CAN configuration ID because the unit is meant for another vehicle, such as a used unit with different software or hardware.
- Open circuit in the CAN cabling linking the unit to the central electronic module (CEM).
Hva du kan gjøre
- 1Check that the steering wheel module or angle sensor is intended for your car. A used part from another car can cause this code.
- 2Check that the connectors are firmly seated and not corroded, and have a workshop measure the wiring.
- 3If no other fault is found, a workshop can load new software into the angle sensor, but only after agreeing it with you.
- 4The angle sensor is part of the stability system. Have a workshop carry out the fault tracing and any software loading rather than working on the steering wheel yourself.
Symptomer du kan merke4
- The anti-spin warning lamp lights up on cars of model year 2002 and earlier
- The general warning lamp lights up on cars of model year 2003 and later
- The stability function does not work
- A message appears in the text display
Hva feilen kan påvirke1
- The sensor cannot communicate normally on the CAN network
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.