Hopp til innhold
    OBD Tuning
    SEND TIL OSS
    SEND TIL OSS
    Hjem
    Feilkoder
    VOLVO
    SODR-U014000
    VOLVO

    SODR-U014000 - Lost Communication With Central electronic module. General Failure Information. No sub type information

    System

    Blindsone-sensor H (SODR)

    Volvo-modeller feilkoden gjelder for

    Gjelder følgende modeller:

    6 modeller

    S60 (2011–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), XC60 (2009–)

    Vis modeller per årsmodell og motor (6)
    • Volvo S60 (2011–)2014–2015
    • Volvo V40 (2013–)2013–2015
    • Volvo V40 Cross Country (2013–)2013–2015
    • Volvo V60 (2011–)2014–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo XC60 (2009–)2014–2015

    Hva betyr feilkoden?

    The right side obstacle detection control module (SODR) communicates continuously with the central electronic module (CEM). The code is set when communication between them has been interrupted or is missing. The fault may lie in the wiring or in how the control modules are programmed.

    Mulige årsaker

    • Fault in the central electronic module (CEM) or in the communication to it
    • Open circuit in one or both CAN wires along part of the network
    • Short circuit between the CAN wires, or between a CAN wire and ground or voltage
    • Incorrect signal configuration in the control module that set the code, for example after a replacement where no new software was loaded

    Hva du kan gjøre

    1. 1Read the fault codes in the car; if several control modules hold codes for missing communication, start with the CEM
    2. 2Check that the fuses are intact and that the CEM has a power feed and ground connection
    3. 3Use a multimeter to check that the CAN wires have no open circuit and no short to ground or voltage; disconnect the battery negative lead first
    4. 4Gently wiggle connectors and wires while you measure and see whether the reading changes
    5. 5Clear the fault codes, start the car and read the fault codes again to see whether the fault returns
    6. 6If the code is only stored in the SODR, a workshop needs to reprogram it with the latest software

    Symptomer du kan merke3

    • Blind spot warning (BLIS) stops working
    • Cross traffic alert (CTA) does not work
    • Yellow warning symbol and message in the display

    Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.

    OBD Tuning

    Sveriges ledende ekspertsenter for bilelektronikk. Vi tilbyr profesjonell ECU-tuning, reparasjon av styreenheter og diagnostikk med 12 måneders garanti.

    Tjenester

    • Motoroptimalisering
    • ECU Reparasjon
    • Modulkloning
    • Instrumentpanel
    • SRS / Airbag
    • Startsperre

    Database & Diagnostikk

    • ECU-database
    • DTC Feilkodekatalog
    • Diagnoseguider & Måleverdier
    • AI Feilkodeanalysator
    • Nyheter

    ECU-produsenter

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Selskap

    • Om oss
    • Kontakt
    • Verkstedpartnere
    • Fraktguide
    • Garanti
    • FAQ
    • Vilkår
    • Personvern
    • Nettstedskart

    • Motoroptimalisering
    • ECU Reparasjon
    • Modulkloning
    • Instrumentpanel
    • SRS / Airbag
    • Startsperre

    • ECU-database
    • DTC Feilkodekatalog
    • Diagnoseguider & Måleverdier
    • AI Feilkodeanalysator
    • Nyheter

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Om oss
    • Kontakt
    • Verkstedpartnere
    • Fraktguide
    • Garanti
    • FAQ
    • Vilkår
    • Personvern
    • Nettstedskart

    Besøk oss

    Gjuterigatan 29, Karlstad

    Ring oss

    054-830 480

    E-post oss

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle rettigheter forbeholdt.