Hva betyr feilkode TCM-0408?

Diagnose og feilkodedefinisjon for TCM-0408 (Volvo C30 (2007–2013), Volvo C30 (2007–2013), Volvo C30 (2007–2013)). Bestill reparasjon hos OBD Tuning.

VOLVO

TCM-0408 - Position sensor shift fork 2. Signal to high

System

Girkassestyring (TCM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

4 modeller

C30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)

Vis modeller per årsmodell og motor (10)

Hva betyr feilkoden?

The transmission control module (TCM) engages the gears using shift forks, and each fork has a position sensor. The sensor for shift fork 2 is giving too high a signal, so the module cannot be sure where the fork is and switches to a protective mode.

Mulige årsaker

Sensor wire shorted to supply voltage
Damaged position sensor
Fault in the transmission control module

Hva du kan gjøre

1Check the transmission module connectors for oil ingress, poor contact and corrosion
2Check that the battery is charged, as low voltage can cause false transmission faults
3Have a workshop check the sensor supply with diagnostic equipment – if the fault is in the module, it must be replaced and programmed
4Avoid driving far with the fault, especially if the car loses drive or shifts harshly

Symptomer du kan merke4

Engine (Check Engine) warning lamp on and warning message shown
Gear changes are harsh, jerky or happen at the wrong time
Gear changes take a long time
In the worst case the car may not drive forwards or backwards

Hva feilen kan påvirke1

The transmission enters a protective mode with limited function

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.