VOLVO
TCM-041C - Position sensor shift fork 4. Faulty position
System
Girkassestyring (TCM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
4 modellerC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Vis modeller per årsmodell og motor (10)
- Volvo C30 (2007–2013)2008Kun motor: D4204T · Kun girkasse: MPS6
- Volvo C30 (2007–2013)2009–2010Kun motor: B4204S3, D4204T · Kun girkasse: MPS6
- Volvo C30 (2007–2013)2011–2013Kun motor: B4204S3 · Kun girkasse: MPS6
- Volvo C70 (2006–2013)2009–2010Kun motor: D4204T · Kun girkasse: MPS6
- Volvo S40 (2004–2013)2008Kun motor: D4204T · Kun girkasse: MPS6
- Volvo S40 (2004–2013)2009–2010Kun motor: B4204S3, D4204T · Kun girkasse: MPS6
- Volvo S40 (2004–2013)2011–2012Kun motor: B4204S3 · Kun girkasse: MPS6
- Volvo V50 (2004–2013)2008Kun motor: D4204T · Kun girkasse: MPS6
- Volvo V50 (2004–2013)2009–2010Kun motor: B4204S3, D4204T · Kun girkasse: MPS6
- Volvo V50 (2004–2013)2011–2012Kun motor: B4204S3 · Kun girkasse: MPS6
Hva betyr feilkoden?
The sensor for shift fork 4 indicates that the fork is out of its position, although the shaft speeds for the gear in use look normal. The transmission control module (TCM) has therefore found that the sensor's position and the fork's real position do not agree.
Mulige årsaker
- Damaged position sensor
- The sensor gives the control module an incorrect position
- Incorrect voltage supply to the sensor
- Damaged transmission control module (TCM)
Hva du kan gjøre
- 1Read out the fault codes from the transmission control module and deal first with any codes that may share the same cause
- 2Have a workshop with diagnostic equipment check the voltage supply to the position sensors; if it is outside the normal range, the fault is inside the control module
- 3If you have diagnostic equipment, compare the position value for shift fork 4 with the others in live data and see whether it stands out clearly
- 4If a value is outside or at the limit, a workshop should replace the mechatronic unit; if readings are within limits, the fault has probably been sporadic
- 5If the fault is inside the control module, it must be replaced, and a new module is delivered without software and must be programmed by a workshop
Symptomer du kan merke5
- Check engine light comes on or behaves abnormally
- Message and yellow warning symbol in the display
- Gears shift hard or jerky, sometimes or all the time
- Gear changes take too long to complete, sometimes or all the time
- No forward or reverse movement with a gear selected
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.