Hva betyr feilkode TCM-P280200?

Diagnose og feilkodedefinisjon for TCM-P280200 (Volvo S60 (2011–), Volvo S80 (2007–), Volvo V40 (2013–)). Bestill reparasjon hos OBD Tuning.

VOLVO

TCM-P280200 - Transmission Gear Position Sensor "B" Circuit Low. General Failure Information. No sub type information

System

Girkassestyring (TCM)

Volvo-modeller feilkoden gjelder for

Gjelder følgende modeller:

9 modeller

S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

Vis modeller per årsmodell og motor (9)

Hva betyr feilkoden?

Gear position sensor B, which is part of the transmission control module (TCM), provides information about the selected gear position. The code shows that the signal from the sensor is too low, so the control module cannot read the gear position as it should. For this reason the engine is not allowed to start while the fault is present.

Mulige årsaker

Contact resistance, oxidation or poor connection in connectors and joints
Signal wire shorted to ground
Misadjusted gear position sensor
Fault inside the TCM itself

Hva du kan gjøre

1Read and note the code, clear it and road test the car to see whether it returns
2Have a workshop check that the selector cable is correctly adjusted
3If you have a diagnostic tool: move the selector through all positions and check in live data that the selected position is shown
4If the fault returns, have a workshop check the signal wire to ground and the control module, and replace the transmission control module if needed

Symptomer du kan merke3

Message in the display
The malfunction indicator lamp (check engine light) comes on or behaves abnormally
The engine does not start

Hva feilen kan påvirke2

The control module does not allow the engine to be started while the fault is active
The control module switches to a fallback program

Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.