VOLVO
TCM-P301400 - Transmission Requested Mode - Signal Failure. General Failure Information. No sub type information
System
Girkassestyring (TCM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2014–2015Kun girkasse: TG-81SC
- Volvo S80 (2007–)2014–2015Kun girkasse: TG-81SC
- Volvo V40 (2013–)2015Kun girkasse: TG-81SC
- Volvo V40 Cross Country (2013–)2015Kun girkasse: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Kun girkasse: TG-81SC
- Volvo V60 Cross Country (2015–)2015Kun girkasse: TG-81SC
- Volvo V70 (2008–)2014–2015Kun girkasse: TG-81SC
- Volvo XC60 (2009–)2014–2015Kun girkasse: TG-81SC
- Volvo XC70 (2008–)2014–2015Kun girkasse: TG-81SC
Hva betyr feilkoden?
The transmission control module (TCM) receives no valid signal from the engine control module about the requested transmission mode, that is, when the transmission should be disengaged. The control module uses a default value in its place, and automatic engine start and stop is switched off.
Mulige årsaker
- The cause should be sought in the engine control module (ECM)
- Temporary breaks or a short on the CAN wire between the ECM and the TCM
Hva du kan gjøre
- 1Read the codes in the central electronics control module (CEM) and the engine control module first, and deal with them
- 2Do not clear this code until the fault in the engine control module is fixed and its code is cleared
- 3If no codes are stored, have a workshop troubleshoot the CAN network
Symptomer du kan merke1
- Automatic engine start and stop does not work, including at idle
Hva feilen kan påvirke2
- The transmission control module uses a default value for the signal
- Automatic engine start and stop is switched off
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.