VOLVO
TCM-P301500 - Torque Limit Delay - Signal Failure. General Failure Information. No sub type information
System
Girkassestyring (TCM)
Volvo-modeller feilkoden gjelder for
Gjelder følgende modeller:
9 modellerS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Vis modeller per årsmodell og motor (9)
- Volvo S60 (2011–)2014–2015Kun girkasse: TG-81SC
- Volvo S80 (2007–)2014–2015Kun girkasse: TG-81SC
- Volvo V40 (2013–)2015Kun girkasse: TG-81SC
- Volvo V40 Cross Country (2013–)2015Kun girkasse: TG-81SC, TG-81SC AWD
- Volvo V60 (2011–)2014–2015Kun girkasse: TG-81SC
- Volvo V60 Cross Country (2015–)2015Kun girkasse: TG-81SC
- Volvo V70 (2008–)2014–2015Kun girkasse: TG-81SC
- Volvo XC60 (2009–)2014–2015Kun girkasse: TG-81SC
- Volvo XC70 (2008–)2014–2015Kun girkasse: TG-81SC
Hva betyr feilkoden?
The transmission control module (TCM) receives no valid signal for the requested torque limit from the engine control module on HS-CAN 2. The signal helps decide shift points and adjusts the system pressure in the transmission. The control module then uses the matching signal on HS-CAN 1 instead.
Mulige årsaker
- The cause should be sought in the engine control module (ECM)
- Temporary breaks or a short on the CAN wire between the ECM and the TCM
Hva du kan gjøre
- 1Read the codes in the central electronics control module (CEM) and the engine control module first, and deal with them
- 2Do not clear this code until the fault in the engine control module is fixed and its code is cleared
- 3If no codes are stored, have a workshop troubleshoot the CAN network
Symptomer du kan merke1
- No noticeable symptoms for the driver
Hva feilen kan påvirke2
- The control module uses the signal from HS-CAN 1 instead
- If that signal is also faulty, the control module uses a default value
Generell veiledning for bileiere. Feilsøking på bilen kan peke på en annen årsak.