VOLVO
ABS-00B4 - Communication control unit SAS control unit not initiated
System
Bremssystem (ABS)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleS60 (2001–2009), S80 (1999–2006), V70 (2000–2008), V70 XC / XC70 (2001–2007)
Modelle nach Baujahr und Motor anzeigen (4)
Was bedeutet der Fehlercode?
The steering angle sensor module (SAS) is initialised when the steering wheel is turned in either direction shortly after the car is started. If this does not happen, no steering angle is sent to the ABS module. This code applies only to cars with stability control, and while it is present anti-spin and stability are blocked. The cause is either a fault on the CAN data network or an internal fault in the SAS control unit.
Mögliche Ursachen
- Disturbances on the CAN network
- Internal fault in the steering angle sensor module (SAS)
Was Sie tun können
- 1Turn the steering wheel in either direction after starting and check whether the fault clears
- 2Read the codes in the steering angle sensor control unit and trace them according to the system information
- 3Check the battery and its terminals, since voltage problems can disturb the CAN network
- 4If the fault remains, have a workshop with diagnostic equipment check the network and the control unit
- 5ABS, stability and steering are safety-critical – do not work on the ABS module or the steering angle sensor yourself, have a workshop do it
Symptome, die Sie bemerken können3
- Anti-spin does not work
- Stability function is absent
- Anti-spin warning lamp lit
Was der Fehler beeinflussen kann2
- Anti-spin function is blocked
- Stability function is blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.