VOLVO
ADM-0006 - Pump, additive. Signal missing
System
Additiv-Dosiermodul (ADM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (9)
- Volvo C30 (2007–2013)2007–2010Nur Motor: D4164T, D4204T
- Volvo C30 (2007–2013)2011Nur Motor: D4164T
- Volvo C70 (2006–2013)2008–2010Nur Motor: D4204T
- Volvo S40 (2004–2013)2005–2006Nur Motor: D4164T, D4204T, D4204T2
- Volvo S40 (2004–2013)2007–2010Nur Motor: D4164T, D4204T
- Volvo S40 (2004–2013)2011Nur Motor: D4164T
- Volvo V50 (2004–2013)2005–2006Nur Motor: D4164T, D4204T, D4204T2
- Volvo V50 (2004–2013)2007–2010Nur Motor: D4164T, D4204T
- Volvo V50 (2004–2013)2011Nur Motor: D4164T
Was bedeutet der Fehlercode?
The additive dosing module (ADM) has found an open circuit in the wiring to the additive pump. Without a signal from the pump circuit, additive cannot be dosed, and the fault shows up as the emissions warning lamp. The pump is built into the additive tank, so it is not replaced separately.
Mögliche Ursachen
- Poor contact, resistance or corrosion at the terminals
- Break in the wiring to the additive pump
- Damaged additive pump
- Damaged additive dosing module (ADM)
Was Sie tun können
- 1Check the connector at the additive tank for looseness, contact resistance and oxidation
- 2Look for breaks in the wiring to the pump, especially where it enters the tank
- 3Clear the code and check whether it returns
- 4If the code returns with no visible cause, the additive tank may need replacing because the pump is inside it
- 5If the fault remains, have a workshop with diagnostic equipment check the pump and the module
Symptome, die Sie bemerken können1
- Emissions warning lamp lit
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.