VOLVO
BCM-C006428 - Roll Rate Sensor. General Signal Failures. Signal bias level out of range / zero adjustment failure
System
Bremssteuergerät (BCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
13 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V50 (2004–2013), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (14)
- Volvo C30 (2007–2013)2011–2013Nur Motor: D4162T, D5204T, D5204T5
- Volvo C70 (2006–2013)2011Nur Motor: D5204T, D5204T5
- Volvo C70 (2006–2013)2012–2013Alle Motoren außer: B5254T7
- Volvo S40 (2004–2013)2011–2012Nur Motor: D4162T, D5204T, D5204T5
- Volvo S60 (2011–)2011–2015
- Volvo S80 (2007–)2009–2015
- Volvo V40 (2013–)2013–2015
- Volvo V40 Cross Country (2013–)2013–2015
- Volvo V50 (2004–2013)2011–2012Nur Motor: D4162T, D5204T, D5204T5
- Volvo V60 (2011–)2011–2015
- Volvo V60 Cross Country (2015–)2015
- Volvo V70 (2008–)2009–2015
- Volvo XC60 (2009–)2009–2015
- Volvo XC70 (2008–)2009–2015
Was bedeutet der Fehlercode?
The stability sensor has a correction value for its individual deviation in roll motion, and the value has been judged unreasonable. The fault often lies in how the sensor is mounted or in a missing calibration, not in the brake control module.
Mögliche Ursachen
- Stability sensor incorrectly fitted
- Loose stability sensor
- Bent bracket for the stability sensor
- Internal fault in the stability sensor
- Brake control module calibration missing
Was Sie tun können
- 1Read and note the code, clear it and road test the car to see whether it returns
- 2Check that the stability sensor is secure and correctly fitted to the bracket under the passenger seat, and that the bracket is not bent
- 3Have a workshop calibrate the brake control module and check the sensor with diagnostic equipment. Read the code status without switching the ignition off after the road test
- 4If the fault remains, the stability sensor needs replacing by a workshop, and calibration must be done afterwards
- 5The braking system is safety critical: do not work on the stability sensor or braking system yourself; leave this to a workshop
Symptome, die Sie bemerken können5
- Anti-spin function does not work
- Front monitoring and active safety do not work
- Brake pedal requires more force than normal
- Cruise control will not engage
- Stability function does not work
Was der Fehler beeinflussen kann3
- Traction control and stability control can be disabled
- Active yaw control (AYC) is blocked
- Roll control (RSC) is blocked
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.