VOLVO
BCM-C110768 - Communication between control modules. Algorithm error. Event-controlled information
System
Bremssteuergerät (BCM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
1 ModellXC90 (2003–)
Was bedeutet der Fehlercode?
The brake control module (BCM) is waiting for the steering angle sensor to be initialised, which happens when the steering wheel is turned a little after start-up. If initialisation has not taken place after a longer distance at a sufficient speed, the code is set, and stability control stays switched off until the sensor is initialised.
Mögliche Ursachen
- The steering angle sensor has not been initialised after a longer distance
- The steering wheel has not been turned after the car was started
Was Sie tun können
- 1Drive a short distance and turn the steering wheel a little in both directions so the steering angle sensor initialises
- 2Check whether the traction control warning lamp goes out once the sensor has been initialised
- 3If this code is stored on its own it can be cleared once the steering angle sensor is initialised
- 4If a steering angle sensor code is also present, have a workshop diagnose it with diagnostic equipment
- 5The brake and stability systems are safety-critical, so have a workshop carry out any work on the module
Symptome, die Sie bemerken können2
- General warning lamp on
- Anti-skid function does not work
Was der Fehler beeinflussen kann1
- Dynamic stability control (AYC) is disabled
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.