Was bedeutet der Fehlercode BCM-C110812?

Diagnose und Fehlercodedefinition für BCM-C110812 (Volvo V60 (2011–), Volvo V60 (2011–)). Steuergerätereparatur bei OBD Tuning.

VOLVO

BCM-C110812 - Pedal Sensor(s) Supply Voltage. General Electrical Failures. Circuit short to battery

System

Bremssteuergerät (BCM)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

1 Modell

V60 (2011–)

Modelle nach Baujahr und Motor anzeigen (2)

Was bedeutet der Fehlercode?

The brake control module (BCM) has registered that the voltage to the brake pressure and pedal position sensors is too high. The fault means a wire is most likely shorted to supply voltage, and the stability functions are then switched off. The fault can only be detected once the test has started and the conditions are met.

Mögliche Ursachen

Wire shorted to supply voltage
Wire shorted to ground

Was Sie tun können

1Check that the fuses are intact; their locations are in the owner's manual or on the fuse box cover
2Where possible, check that the relevant functions work using the switches, controls and a road test
3Check the wiring to the sensors for chafing and places where it could have touched a live supply
4Read the codes with diagnostic equipment and correct the short before replacing any component
5The brake system is safety-critical, so avoid driving with reduced braking function and have a workshop repair the fault

Symptome, die Sie bemerken können3

Traction control and anti-skid warning lamps show a fault
Traction control does not work
Stability function does not work

Was der Fehler beeinflussen kann2

Traction control and stability control are switched off
Dynamic stability control (AYC) is disabled

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.