Was bedeutet der Fehlercode BECM-C107600?

Diagnose und Fehlercodedefinition für BECM-C107600 (Volvo V60 (2011–), Volvo V60 (2011–)). Steuergerätereparatur bei OBD Tuning.

VOLVO

BECM-C107600 - Hybrid/EV Battery External Isolation Resistance Test. General Failure Information. No sub type information

System

Batteriesteuergerät (BECM)

Volvo-Modelle, für die dieser Fehlercode gilt

Gilt für folgende Modelle:

1 Modell

V60 (2011–)

Modelle nach Baujahr und Motor anzeigen (2)

Was bedeutet der Fehlercode?

Before a high voltage battery can be put into use, its insulation must be measured, and the BECM must be programmed after an approved measurement. The code is set when an attempt has been made to activate a battery that is not yet approved and has not had new software loaded.

Mögliche Ursachen

Insulation measurement and related BECM programming have not been done

Was Sie tun können

1This code is a workshop task, since the insulation measurement needs diagnostic equipment
2Have a workshop carry out the insulation measurement and the programming of the BECM before the battery is used
3The high voltage system should only be handled by qualified personnel, so have a workshop carry out all work on the battery and other high voltage parts

Symptome, die Sie bemerken können4

Red warning symbol and message in the display
Charging of the high voltage battery stops or works poorly
Drive modes PURE, SAVE and AWD disengage automatically or cannot be selected
The combustion engine runs more often than normal in HYBRID mode

Was der Fehler beeinflussen kann2

The high voltage battery cannot be charged
Electric propulsion is not possible

Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.