Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    CEM-8A25
    VOLVO

    CEM-8A25 - Gas discharge lamp module (GDL) right-hand. Faulty signal

    System

    Zentralelektronik (CEM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    4 Modelle

    C30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)

    Modelle nach Baujahr und Motor anzeigen (4)
    • Volvo C30 (2007–2013)2007–2011
    • Volvo C70 (2006–2013)2006–2011
    • Volvo S40 (2004–2013)2004–2007
    • Volvo V50 (2004–2013)2004–2007

    Was bedeutet der Fehlercode?

    The right-hand gas discharge lamp module (GDL) reports an internal fault to the central electronic module (CEM). Although the code is named faulty signal, the cause can lie in the module, in the lamp housing or in the signal wiring between them. The lamp and the wiring are therefore checked first.

    Mögliche Ursachen

    • The right-hand gas discharge lamp module (GDL) is faulty
    • The right-hand lamp housing is faulty
    • Open circuit in the signal wire between the right-hand lamp housing and the gas discharge lamp module
    • The signal wire between the lamp housing and the module is short-circuited to battery voltage
    • The signal wire between the lamp housing and the module is short-circuited to ground

    Was Sie tun können

    1. 1Switch on the low beam. If the right lamp stays dark, the fault is likely permanent; if it lights but the code was stored earlier, it is intermittent
    2. 2Switch the ignition off and unplug the connectors at the right headlamp. Check that they are clean, firmly fitted and not damaged or corroded
    3. 3Use a multimeter to check that the signal wires between the headlamp and the module are not broken and have no contact with ground or battery voltage
    4. 4After a recent refit, make sure the igniter sits properly. It carries high voltage, so leave other work to a workshop
    5. 5If the fault remains, have a workshop replace the module. After replacement the car data must be programmed in and the position sensors recalibrated

    Symptome, die Sie bemerken können1

    • The right low beam does not work

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.