Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    CEM-B10F411
    VOLVO

    CEM-B10F411 - Right front position light. General Electrical Failures. Circuit short to ground

    System

    Zentralelektronik (CEM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    9 Modelle

    S60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Modelle nach Baujahr und Motor anzeigen (9)
    • Volvo S60 (2011–)2011–2015
    • Volvo S80 (2007–)2007–2015
    • Volvo V40 (2013–)2013–2015
    • Volvo V40 Cross Country (2013–)2013–2015
    • Volvo V60 (2011–)2011–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo V70 (2008–)2008–2015
    • Volvo XC60 (2009–)2009–2015
    • Volvo XC70 (2008–)2008–2015

    Was bedeutet der Fehlercode?

    The CEM feeds the right front position light directly from an output. The code is stored when the signal from the output is too low, which can be caused by the supply cable being shorted to ground. On XC60 cars built before mid-November 2009, the position and side marker lights on the same side share one output, so a broken side marker bulb can also make the position light go out.

    Mögliche Ursachen

    • The supply cable is short-circuited to ground
    • Damaged front side marker light
    • Defective front position light

    Was Sie tun können

    1. 1Replace the bulb in the right side marker light, start the car again and check whether the code returns
    2. 2Check that the relevant fuses are intact. Their locations are in the owner's manual or on the fuse box cover
    3. 3Check that the right front position light is secure and its connectors are clean and free from corrosion
    4. 4Use a multimeter to check that the supply cable to the position light has no contact with ground (the body)
    5. 5Look for chafing on the cable, especially where it may have touched the body
    6. 6If the fault returns, have a workshop with diagnostic equipment check the control module output and the wiring

    Symptome, die Sie bemerken können3

    • Right side marker or position light does not work
    • Text message in the display with a yellow warning symbol
    • The bulb failure warning in the instruments comes on or behaves abnormally

    Was der Fehler beeinflussen kann2

    • The output switches off in the driving cycle in which the fault is detected
    • Clearing the fault codes and starting a new driving cycle resets the output

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.