Zum Inhalt springen
    OBD Tuning
    SENDEN SIE AN UNS
    SENDEN SIE AN UNS
    Startseite
    Fehlercodes
    VOLVO
    CEM-P165312
    VOLVO

    CEM-P165312 - Power Steering Output Circuit. General Electrical Failures. Circuit short to battery

    System

    Zentralelektronik (CEM)

    Volvo-Modelle, für die dieser Fehlercode gilt

    Gilt für folgende Modelle:

    7 Modelle

    S60 (2011–), S80 (2007–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)

    Modelle nach Baujahr und Motor anzeigen (7)
    • Volvo S60 (2011–)2011–2015
    • Volvo S80 (2007–)2007–2015
    • Volvo V60 (2011–)2011–2015
    • Volvo V60 Cross Country (2015–)2015
    • Volvo V70 (2008–)2008–2015
    • Volvo XC60 (2009–)2009–2015
    • Volvo XC70 (2008–)2008–2015

    Was bedeutet der Fehlercode?

    The CEM sends a frequency-modulated signal to the speed-dependent power steering module (HPAS), and the signal wire is shorted to supply voltage. The voltage then stays constantly high, and the speed-dependent power steering may stop regulating. The fault applies to the V60, S60 and similar models that have this system.

    Mögliche Ursachen

    • The signal wire to the HPAS module is shorted to supply voltage

    Was Sie tun können

    1. 1Start the engine and turn the steering wheel slowly from side to side. If it is stiff when the car is stationary, the fault is active
    2. 2Check the power steering module fuse in the engine bay relay and fuse box. If it has blown, check its circuit for a short to earth before replacing it
    3. 3Use a multimeter to check that the signal wire has no contact with supply voltage with the ignition on
    4. 4With a diagnostic tool, clear the fault codes and run a short test. If the fault returns straight away, it is active
    5. 5Steering is a safety function. Have a workshop repair the fault promptly rather than putting it off
    6. 6After the work, check that the steering wheel turns easily and that the fault code does not return

    Symptome, die Sie bemerken können1

    • The power steering assistance control does not work

    Was der Fehler beeinflussen kann2

    • The function switches off during the driving cycle in which the fault is detected
    • After 100 driving cycles with the fault present, the function is switched off permanently

    Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.

    OBD Tuning

    Schwedens führendes Kompetenzzentrum für Automotorelektronik. Wir bieten professionelle ECU-Optimierung, Steuergerätereparatur und Diagnose mit 12-monatiger Garantie.

    Dienstleistungen

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    Datenbank & Diagnose

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    ECU-Hersteller

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    Unternehmen

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    • Motoroptimierung
    • ECU-Reparatur
    • Modul-Klonen
    • Kombiinstrument
    • SRS / Airbag
    • Wegfahrsperre

    • ECU-Datenbank
    • DTC Fehlercodekatalog
    • Diagnoseanleitungen & Messwerte
    • KI-Fehlercode-Analysator
    • Neuigkeiten

    • Bosch
    • Continental
    • Delphi
    • Delco
    • Denso
    • Magneti Marelli
    • Siemens / VDO
    • Keihin
    • Temic

    • Über uns
    • Kontakt
    • Workshop-Partner
    • Versandanleitung
    • Garantie
    • Häufig gestellte Fragen
    • AGB
    • Datenschutz
    • Sitemap

    Besuchen Sie uns

    Gjuterigatan 29, Karlstad

    Rufen Sie uns an

    054-830 480

    Schreiben Sie uns eine E-Mail

    service@obdtuning.se

    © 2026 OBD Tuning Karlstad. Alle Rechte vorbehalten.