CEM-U000188
VOLVO
CEM-U000188 - High Speed CAN Communication Bus. Bus Signal / Message Failures. Bus off
System
Zentralelektronik (CEM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
Was bedeutet der Fehlercode?
The module has disconnected itself from the high speed CAN, so-called bus-off, after its message traffic became faulty. The cause is most often a break in one or both CAN wires in part of the network, or a short between the internal CAN wires. Starting and driving can then be affected.
Mögliche Ursachen
- Open circuit in one or both CAN wires in part of the network
- Short circuit between the internal CAN wires
Was Sie tun können
- 1Clear the fault codes, start the car and read them again. If bus-off returns straight away, the fault is active
- 2Check the high speed harness for breaks, chafing and pinch damage, especially where it passes through a grommet
- 3Check the connectors on the network for loose connections, corrosion and moisture
- 4With a diagnostic tool, read the fault codes from all control modules. A module that has gone into bus-off often shows no other faults
- 5Gently flex the harness with the ignition on and see whether the fault code changes
- 6Have a workshop measure the resistance on the network, since it requires the network to be separated
Symptome, die Sie bemerken können5
- The engine does not start even though the starter turns
- Poor performance and lack of power
- The throttle response hesitates, surges or is jerky
- Cruise control cannot be engaged
- The speedometer and tachometer show wrong readings
Was der Fehler beeinflussen kann2
- The module switches itself off (bus-off) and stays off until its power supply is cut
- At the next power-up the module makes new attempts to communicate
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.