VOLVO
CEM-U201841 - Control Module Software #3. System Internal Failures. General checksum failure
System
Zentralelektronik (CEM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (9)
Was bedeutet der Fehlercode?
The central electronic module (CEM) has found an internal software fault, with a checksum that does not match. The fault may be due to a software download that failed, or to an internal fault in the module. It is stored while the ignition is on and can affect starting, driving, cruise control and several gauges.
Mögliche Ursachen
- Faulty software installed in the central electronic module (CEM)
Was Sie tun können
- 1Read and clear the code, then road test the car and see whether the fault returns
- 2Has the software been reloaded recently? If that update was interrupted it may need to be done again
- 3Check that the battery is holding a good charge, since low voltage can stop an update from completing
- 4If the fault returns after a reload, have a workshop replace the central electronic module (CEM)
Symptome, die Sie bemerken können5
- The engine does not start
- Poor performance and lack of power, especially when pulling away
- Jerky running and hesitation under acceleration
- Cruise control does not engage
- The speedometer and tachometer show wrong readings
Was der Fehler beeinflussen kann1
- The functions of the central electronic module (CEM) are restricted
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.