VOLVO
DDM-DD20 - LIN communication camera module Internal fault
System
Fahrertürmodul (DDM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleC30 (2007–2013), C30 Electric (2011–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The driver door module communicates over LIN with the camera on the driver side of the car, which is part of the blind spot information system (BLIS). The fault is stored when the module registers an internal fault in the communication with the camera. The cause is then the camera in the driver door.
Mögliche Ursachen
- Fault inside the driver-side camera
Was Sie tun können
- 1Start the engine and check that the LEDs flash when the blind spot system is activated
- 2Check that the fuses are intact
- 3Inspect the wires between the driver door and the camera for visible damage
- 4If the code does not return after a road test, no action is needed, as it was most likely caused by a temporary fault
- 5If the fault remains, have a workshop with diagnostic equipment replace the camera on the left or right side, whichever is relevant
Symptome, die Sie bemerken können2
- An LED does not light up
- A message is shown in the text display
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.