VOLVO
DDM-U040100 - Invalid Data Received from ECM/PCM A. General Failure Information. No sub type information
System
Fahrertürmodul (DDM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
5 ModelleS60 (2011–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–)
Modelle nach Baujahr und Motor anzeigen (5)
Was bedeutet der Fehlercode?
The driver or passenger door module continuously receives information about the outside temperature from the engine control module (ECM) and checks the quality of the signal. The fault is stored when the ECM reports a lower signal quality than the door module accepts. The door module then uses the temperature from its own built-in sensor instead.
Mögliche Ursachen
- The cause lies in the engine control module (ECM), which sends the signal
Was Sie tun können
- 1Read the codes in the engine control module (ECM) with diagnostic equipment, as fault finding is done there
- 2Check that the fuses are intact
- 3Do not clear the code until the fault in the engine control module has been repaired, as the code will then return
- 4Check whether the engine control module has further fault codes that may give a clue
- 5If the fault remains, have a workshop repair the fault in the engine control module and then clear the code
Symptome, die Sie bemerken können1
- No noticeable symptoms for the driver
Was der Fehler beeinflussen kann1
- The door module uses the temperature from its own built-in sensor instead
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.