VOLVO
DEM-P188914 - Oil Pressure Pump Performance. General Electrical Failures. Circuit short to ground or open
System
Allradantrieb (DEM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
7 ModelleS60 (2011–), S80 (2007–), V60 (2011–), V70 (2008–), XC60 (2009–), XC70 (2008–), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (12)
- Volvo S60 (2011–)2011–2012
- Volvo S80 (2007–)2007–2012
- Volvo V60 (2011–)2011–2012
- Volvo V70 (2008–)2008–2012
- Volvo XC60 (2009–)2009–2012
- Volvo XC70 (2008–)2008–2012
- Volvo XC90 (2003–)2005Nur Getriebe: TF-80SC AWD
- Volvo XC90 (2003–)2006Nur Motor: B8444S · Nur Getriebe: TF-80SC AWD
- Volvo XC90 (2003–)2007–2010Nur Motor: B6324S, B8444S · Nur Getriebe: TF-80SC AWD
- Volvo XC90 (2003–)2011Nur Motor: B6324S5, B8444S · Nur Getriebe: TF-80SC AWD
- Volvo XC90 (2003–)2012Nur Motor: B6324S5 · Nur Getriebe: TF-80SC AWD
- Volvo XC90 (2003–)2013–2014Nur Motor: B6324S5, D5244T18 · Nur Getriebe: TF-80SC AWD
Was bedeutet der Fehlercode?
The four-wheel drive control module (DEM) monitors the signal from the oil pressure pump, which supplies pressure to the four-wheel drive clutch. When the signal falls outside the permitted range, the module treats it as an electrical fault. The usual cause is a cable shorted to ground or an interruption in the supply to the pump.
Mögliche Ursachen
- The signal wire from the pump is shorted to ground
- Interruption in the voltage supply to the pump
- The voltage supply cable is shorted to ground
- Loose, corroded or damaged connector between the pump and the control module
- Damaged oil pressure pump
Was Sie tun können
- 1Read off the fault code, note it and clear it. Test drive the vehicle to see if the fault returns
- 2Check that the fuses are intact; their locations are in the owner's manual or on the fuse box cover
- 3Check the connectors at the pump and the control module: they should be firmly seated and free from corrosion
- 4Follow the wiring between the control module and the pump for chafing and pinched areas, and use a multimeter to confirm it has no contact with ground (body)
- 5If you have a diagnostic tool, activate the pump motor and listen for it to start and run smoothly. If it starts and then stops, the fault may have been intermittent
- 6If the fault returns, have a workshop check the pump and replace it if it is damaged
Symptome, die Sie bemerken können2
- Four-wheel drive does not work
- Warning symbol and text message in the display
Was der Fehler beeinflussen kann1
- Four-wheel drive is disengaged
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.