VOLVO
DIM-U000155 - High Speed CAN Communication Bus. System Programming Failures. Not configured
System
Kombiinstrument (DIM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleS60 (2011–), S80 (2007–), V40 (2013–), V40 Cross Country (2013–), V60 (2011–), V60 Cross Country (2015–), V70 (2008–), XC60 (2009–), XC70 (2008–)
Modelle nach Baujahr und Motor anzeigen (10)
Was bedeutet der Fehlercode?
Although the code is named a programming fault, it concerns disturbances on the high-speed CAN network (HS-CAN). The code is set when communication on the network is disturbed by another control module, or when the instrument's own messages cause disturbance. The instrument lighting and dimmer then stop working.
Mögliche Ursachen
- Incorrect configuration
- Short circuit between the CAN wires
- Open circuit in one of the CAN wires
- Disturbance from another control module on the same part of the CAN network
- Damaged instrument panel module (DIM)
Was Sie tun können
- 1Read off the fault codes in the other control modules first and remedy them; they may show where the disturbance comes from
- 2Check that the fuses are intact; their locations are in the owner's manual or on the fuse box cover
- 3Follow the CAN wiring for chafing and pinched areas, and check the connectors for oxidation and loose fit
- 4If you have a diagnostic tool, read which control modules respond on the CAN network and note whether any are missing
- 5Clear the fault code and test drive the vehicle. If the fault returns, have a workshop carry out a CAN fault-finding procedure and check the configuration
Symptome, die Sie bemerken können1
- The instrument lighting and dimmer do not work
Was der Fehler beeinflussen kann2
- The instrument switches itself off and stays off until the power supply to it has been broken
- At the next power-on the instrument tries to communicate again
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.