VOLVO
ECM-0001 - Secondary speed. Signal faulty.
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleS70 (1997–2000), S80 (1999–2006), V70 (1997–2000), V70 (2000–2008)
Was bedeutet der Fehlercode?
The engine control module has received an engine speed value from the needle lift sensor that is too high or changes unreasonably fast. The fault may lie in the sensor, in the connections or in the fuel supply. The code can cause starting problems or engine stalling, and it also affects fuel control, boost pressure and exhaust gas recirculation.
Mögliche Ursachen
- If the code ECM-0000 is also stored, the engine has probably over-revved
- Faulty needle lift sensor
- Poor connection in the wiring to the needle lift sensor
- Fault in the fuel supply
Was Sie tun können
- 1Listen to the engine at idle. If it runs unevenly or stalls, note when this happens
- 2Check the connectors and wiring to the needle lift sensor for play, chafing and corrosion
- 3Check the fuel lines on the suction side for air leaks. Air bubbles in the clear fuel hose while the engine runs point to this
- 4Clear the fault code, road test the car and see whether it returns. If it does, have a workshop investigate the needle lift sensor and the fuel supply
- 5Work on pressure pipes and injectors should be left to a workshop. The fuel system is under very high pressure and can cause serious injury
Symptome, die Sie bemerken können2
- The engine does not start
- The engine stalls
Was der Fehler beeinflussen kann3
- If the signal is too high, fuel control is temporarily switched off until the speed falls below the limit again
- If the signal is faulty, boost pressure is limited to the basic level, so the engine has less power
- If the signal is faulty, exhaust gas recirculation (EGR) is switched off
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.