VOLVO
ECM-0426 - Front temperature sensor, catalytic converter. Faulty signal
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo C30 (2007–2013)2007Nur Motor: D4204T
- Volvo C30 (2007–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo C70 (2006–2013)2008Nur Motor: D4204T
- Volvo C70 (2006–2013)2009–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo S40 (2004–2013)2005–2006Nur Motor: D4204T, D4204T2
- Volvo S40 (2004–2013)2007Nur Motor: D4204T
- Volvo S40 (2004–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo V50 (2004–2013)2005–2006Nur Motor: D4204T, D4204T2
- Volvo V50 (2004–2013)2007Nur Motor: D4204T
- Volvo V50 (2004–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
Was bedeutet der Fehlercode?
The engine control module (ECM) continuously compares the signal from the front temperature sensor in the catalytic converter with a calculated value. If they do not match, the fault is set, and the check is made when the ignition is switched on. The causes are poor contact in the connections, an open or shorted wiring fault to the sensor, or a damaged temperature sensor.
Mögliche Ursachen
- Poor contact, contact resistance or oxidation at the sensor terminals
- Open circuit or short circuit in the wiring to the temperature sensor
- Damaged temperature sensor
Was Sie tun können
- 1Switch off the ignition and check the connector to the front temperature sensor in the converter for looseness, contact resistance and oxidation
- 2Look for damage on the sensor wiring, especially where it runs close to the exhaust pipe and may have chafed
- 3Use a multimeter to check that the signal wire to the sensor has no open circuit or short circuit
- 4Also use a multimeter to check that the supply wire to the sensor has no open circuit or short circuit
- 5If you have a diagnostic tool, compare the front sensor temperature with the rear one in live data after a drive and check that they rise at about the same time
- 6If the fault remains, have a workshop with diagnostic equipment check and, if needed, replace the temperature sensor
Symptome, die Sie bemerken können1
- The check engine lamp lights or behaves abnormally
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.