VOLVO
ECM-0513 - Immobilizer. Faulty signal
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo C30 (2007–2013)2007Nur Motor: D4204T
- Volvo C30 (2007–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo C70 (2006–2013)2008Nur Motor: D4204T
- Volvo C70 (2006–2013)2009–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo S40 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo S40 (2004–2013)2007Nur Motor: D4204T
- Volvo S40 (2004–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo V50 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo V50 (2004–2013)2007Nur Motor: D4204T
- Volvo V50 (2004–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
Was bedeutet der Fehlercode?
The engine control module holds a unique immobiliser code that it compares with the central electronic module (CEM) before the engine may start. If a power cut reaches the engine control module while the comparison is in progress, the fault is set. Low battery voltage can cause this, as can poor contact or a fault in the supply to the engine control module.
Mögliche Ursachen
- Low battery voltage
- Poor contact, resistance or oxidation at the engine module connector
- Open circuit or short to ground in the supply to the engine control module
Was Sie tun können
- 1Check the battery charge and voltage. Low battery voltage can cause the fault code to be set
- 2Check that the fuses are intact. Their locations are shown in the instruction manual or on the fuse box cover
- 3Switch off the ignition and check the connector to the engine control module for looseness, contact resistance and oxidation. Clean it if it is oxidised
- 4Check that the earth point for the engine control module is clean and firmly fixed
- 5Use a multimeter to check that the supply wire to the engine control module has no open circuit and is not shorted to ground
- 6If the fault remains, have a workshop with diagnostic equipment check the immobiliser, as the code has to be compared between the modules
Symptome, die Sie bemerken können2
- The engine does not start or crank, and no clicking sound is heard at a start attempt
- Warning symbol and text message in the display
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.