VOLVO
ECM-060D - Accelerator pedal (AP) position sensor. Faulty signal
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
4 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), V50 (2004–2013)
Modelle nach Baujahr und Motor anzeigen (10)
- Volvo C30 (2007–2013)2007Nur Motor: D4204T
- Volvo C30 (2007–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo C70 (2006–2013)2008Nur Motor: D4204T
- Volvo C70 (2006–2013)2009–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo S40 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo S40 (2004–2013)2007Nur Motor: D4204T
- Volvo S40 (2004–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
- Volvo V50 (2004–2013)2004–2006Nur Motor: D4204T, D4204T2
- Volvo V50 (2004–2013)2007Nur Motor: D4204T
- Volvo V50 (2004–2013)2008–2010Nur Motor: D4204T · Nur Getriebe: MMT6, MPS6
Was bedeutet der Fehlercode?
The engine control module (ECM) checks the two signals from the accelerator pedal position sensor: the PWM signal, which goes directly to the control module, and the analog signal, which goes via the central electronic module (CEM). If either signal disagrees with the value the ECM has calculated, the code is set. The fault can cause poor performance and an engine speed limit.
Mögliche Ursachen
- Loose connections, contact resistance or oxidation at the terminals
- Open circuit or short circuit to earth in the signal cable
- Open circuit in the supply or earth lead to the sensor
- Low battery voltage
- Damaged accelerator pedal position sensor
Was Sie tun können
- 1If you have a diagnostic tool, press the accelerator slowly down and up and check in live data that both the PWM and analog values follow the pedal smoothly, without jumps
- 2If you have a diagnostic tool, read out the fault codes in the central electronic module (CEM) and remedy them first, since the analog signal passes through the CEM
- 3Check the sensor connector for contact resistance and oxidation
- 4Check that the battery is in good condition and that its terminals are tight, since low voltage can cause the fault
- 5With the ignition off, use a multimeter to check that the signal wire has no open circuit or short to earth
Symptome, die Sie bemerken können2
- Poor performance or the car lacks power
- Text message and warning symbol in the display
Was der Fehler beeinflussen kann1
- Engine speed is limited
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.