VOLVO
ECM-141B - Outside temperature sensor. Signal missing
System
Motorsteuergerät (ECM)
Volvo-Modelle, für die dieser Fehlercode gilt
Gilt für folgende Modelle:
9 ModelleC30 (2007–2013), C70 (2006–2013), S40 (2004–2013), S60 (2001–2009), S80 (1999–2006), V50 (2004–2013), V70 (2000–2008), V70 XC / XC70 (2001–2007), XC90 (2003–)
Modelle nach Baujahr und Motor anzeigen (23)
- Volvo C30 (2007–2013)2007Nur Motor: B5254T3
- Volvo C30 (2007–2013)2008–2013Nur Motor: B5254T7
- Volvo C70 (2006–2013)2006–2007Nur Motor: B5254T3
- Volvo C70 (2006–2013)2008–2013Nur Motor: B5254T7
- Volvo S40 (2004–2013)2005–2007Nur Motor: B5254T3
- Volvo S40 (2004–2013)2008Nur Motor: B5254T3, B5254T7
- Volvo S40 (2004–2013)2009–2012Nur Motor: B5254T7
- Volvo S60 (2001–2009)2005–2006Nur Motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2007Nur Motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo S60 (2001–2009)2008–2009Nur Motor: B5204T5, B5244T5, B5254T2
- Volvo S80 (1999–2006)2005–2006Nur Motor: B5204T5, B5244T4, B5254T2, B6294S2, B6294T
- Volvo V50 (2004–2013)2005–2007Nur Motor: B5254T3
- Volvo V50 (2004–2013)2008–2012Nur Motor: B5254T7
- Volvo V70 (2000–2008)2005Nur Motor: B5204T5, B5244T4, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2006–2007Nur Motor: B5204T5, B5244T5, B5254T2, B5254T4
- Volvo V70 (2000–2008)2008Nur Motor: B5254T2
- Volvo V70 XC / XC70 (2001–2007)2005Alle Motoren außer: D5244T
- Volvo V70 XC / XC70 (2001–2007)2006Nur Motor: B5244T4, B5254T2
- Volvo V70 XC / XC70 (2001–2007)2007Nur Motor: B5254T2
- Volvo XC90 (2003–)2005–2006Nur Motor: B5254T2, B6294T
- Volvo XC90 (2003–)2007–2012Nur Motor: B5254T2
- Volvo XC90 (2003–)2013–2014Nur Motor: B5254T9
- Volvo XC90 (2003–)2015
Was bedeutet der Fehlercode?
In the engine control module (ECM) the outside air temperature is compared with a calculated temperature. If the signal is lower than the calculated one, the fault is set, even though the signal itself lies within its normal range. The fault is only checked after a longer drive.
Mögliche Ursachen
- Contact resistance in the connections
- Damaged outside air temperature sensor
- Damaged intake air temperature sensor
- The cause may lie in the central electronics module (CEM)
Was Sie tun können
- 1If the fault code for the intake air temperature sensor is also stored, troubleshoot this code first
- 2Check the outside air temperature sensor connector for contact resistance and oxidation
- 3If you have a diagnostic tool: compare the outside temperature in live data with the intake temperature after the car has stood still for a while; they should be roughly equal
- 4Check that the outside air temperature sensor is seated properly, and have a workshop measure its resistance if needed
- 5Clear the CEM fault code once it has been fixed, and read the fault codes there first, since this code cannot be cleared until the CEM fault is gone
Symptome, die Sie bemerken können3
- Engine warning lamp comes on
- Starting problems, the engine cranks slowly
- The outside temperature gauge does not work or shows wrong values
Was der Fehler beeinflussen kann1
- The engine uses the value from the intake air temperature sensor
Allgemeine Hinweise für Fahrzeughalter. Die Diagnose am Fahrzeug kann eine andere Ursache zeigen.